*Power increases of up to 44 hp and 52 ft/lbs of torque!*
Steeda's ProFlow Cold Air Intake on an otherwise stock 2011 and up 5.0L Mustang has achieved a blistering 1/4 mile time of 11.96 at over 115mph! Steeda was the first manufacturer to get into the 11.90 range on a radial tire. Competitors had to use slicks to keep up.
Steeda Autosports, the world's largest aftermarket manufacturer of Ford performance equipment is once again leading the performance market with our High Velocity Cold Air Intake (CAI) and SCT custom tuning device package.
This intake/tuning package called our Ultimate Induction Pak combines our High Velocity Cold Air Intake with an SCT X4 tuning device for the ultimate easy to install power upgrade.
The high velocity CAI in this package effectively opens up the intake system of Ford's new five-liter power plant and allows it to breath much more freely than the stock intake system allows - taking your 2011 and up 5.0L Mustang to the next level of performance.
To ensure the densest air charge possible we retained the factory cold air feed ducting from the front bumper and sealed the stainless steel shield to the hood to prevent any hot air from being sucked in from around the engine compartment. Other manufacturers have chosen to ignore the factory cold air ducting which is key to keeping the lowest air charge temperatures possible. Steeda was the first company to do this starting in 2010 with our 2010 GT intake and have carried this innovation over to the 2011 model.
Also, a billet aluminum velocity stack and high flow air filter ensure a clean, cool, streamlined air charge straight to the engine. The new high flow "ProFlow" intake tube provides the necessary ports to retain the factory noise tube and PCV tubes.
This Cold Air Intake is so effective at improving airflow into the five-liter engine that a performance tune is not just recommended, it is required for maximum performance!
Combined with the required custom tune using the industry leading SCT X4 Flash Programming Device we have achieved dramatic power increases of up to 44hp and 52ft/lbs of torque!
SCT Tuning is the leader in the Ford tuning industry and Steeda's partner in developing this powerful package.
"SCT has seen the highest horsepower and torque results while using Steeda's Cold Air Kit, over any other brand." - Chris Johnson, President of SCT Tuning
Our power increase it not just a peak number at one point in the band. The actual power increase is spread throughout the entire rpm range so your increased performance is available on demand in any gear at virtually any rpm!
Note: requires a minimum of 91 octane fuel for power gains.
Warning: This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.
Lifetime Tune Program: Purchasing this Steeda Power Package automatically registers you into Steeda's Lifetime Tune Program, at no extra cost! To learn more about Steeda's Lifetime Tune Program, click here.
- Greatly increased horsepower and torque! Up to 44hp & 52 ft/lbs of torque
- Best designed/engineered intake on the market
- Retains factory cold air inlet ducting - critical to keeping temps down
- Easy installation