Stock rotors on the 2005-2010 Mustang V6 4.0L do the job, but age, heat cycling, and road grime take their toll. EBC's RK7253 front rotors replace worn OEM units with G3000 spec cast iron discs that meet original equipment standards for fitment, runout, and durability, now finished in EBC's Gen 3 silver grey Geomet-style corrosion-resistant coating.
Gen 3 silver grey coating sets a new standard. EBC transitioned to this coating in early 2023, applying it directly at the casting plant immediately after machining and washing. That timing matters: bare cast iron begins to surface-corrode within minutes of being washed, so coating the rotor at that exact stage locks out rust before it can start. The result is far higher corrosion resistance compared to the former black etch paint finish, and the silver tone closely matches original rotor colors, keeping the front and rear of the car visually consistent if only one axle is being replaced.
G3000 spec cast iron throughout. EBC specifies G3000 grade iron for its automotive rotors, the same material grade used by OE suppliers. Over 80 percent of EBC's rotor castings are produced in Europe, and 100 percent of sport rotor machining is completed in either the UK or the USA. That sourcing keeps tolerances tight and material consistency high across the production run.
Every rotor is individually runout-inspected. Before leaving the facility, each disc passes through a dedicated runout inspection process. No rotor ships without this check, which confirms disc alignment and guards against the thickness variation that causes pedal pulsation after a few thousand miles of driving.
Product Benefits
- Direct Front Fitment: Engineered specifically for the 2005-2010 Mustang V6 4.0L front axle.
- Gen 3 Corrosion Coating: Silver grey Geomet-style finish applied at the casting plant for maximum rust resistance.
- G3000 Cast Iron Construction: OE-grade material for consistent bite, wear, and thermal performance.
- European Castings, UK/USA Machining: Over 80% of castings sourced in Europe; all sport rotor machining done in the UK or USA.
- 100% Runout Inspected: Every individual rotor is checked on dedicated inspection equipment before shipping.
- OEM Color Match: Silver finish closely matches factory rotor appearance for a uniform look across both axles.
- Drop-In Replacement: Replaces stock rotors with no modification to brackets, calipers, or hardware.
About EBC Brakes: EBC Brakes is a dedicated brake specialist with manufacturing and machining operations in the UK and USA. The brand covers rotors, pads, and brake lines across a wide range of passenger car, truck, and performance applications, with an engineering focus on material quality, dimensional accuracy, and real-world durability.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
Product Specifications & Vehicle Fitment
Review the product details and confirm compatibility with your vehicle before ordering.
| Specification | Details |
|---|---|
| Vehicle Trim | Base |
| Vehicle Fitment | 2005, 2006, 2007, 2008, 2009, 2010 |
| FMSI Pad No. | D1081 |
