*Increases of up to 34 hp and 26 ft/lbs of torque to the rear wheels!*
Steeda's Ultimate Induction Power Pack is a complete performance package that includes Steeda's Cold Air Intake with High Flow Inlet Elbow and SCT Tuner.
Steeda's new Cold Air Kit for the S197 produces the greatest power gains of any Cold Air Kit on the market. Testing has shown increases of up to 38 HP and 30 ft lbs of Torque to the rear wheels!
The kit is supplied with a stainless steel air box with built-in velocity stack. It mounts in the factory location with the supplied rubber trim to seal it against the hood & fender to keep the hot air out. Our tests showed inlet temps a mere 5 degrees above ambient temperature. The Steeda Lifetime Filter can easily be cleaned and re-oiled, making maintenance a snap. All hardware required for installation is included in the kit.
Independent test results have proven gains of over 4 HP and 5 ft/lbs of Torque over the entire RPM range of the so called 'leading brands.'
Used by the top tuners in the industry.
"SCT has seen the highest horsepower and torque results while using Steeda's Cold Air Kit, over any other brand." - Chris Johnson, President of SCT Tuning
Note: Use of Steeda's Cold Air Intake REQUIRES a tune under any application.
Package Includes
- 555-3120 - Steeda Cold Air Kit
- 555-3130 - Steeda High Flow Inlet Elbow
- 388-40470 - SCT BDX w/ Tune
- New tuning devices are shipped out "blank". Upon receiving the device, utilize it to retrieve your vehicle's Strategy Code
- With the strategy code, visit our Custom Tune Request Form. Fill out the requested details on your car.
- Your Custom Steeda Tune will be emailed to you in approximately 7 days. Download the tune onto the device, flash your vehicle and enjoy the new performance.
Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations. Steeda Tuning will not change, remove or alter any emissions control devices on your vehicle.
NOTE: . Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
- Increase horsepower and torque!
- Tuning eliminated factory throttle lag, greatly improving throttle response
- Lifetime use filter
- Stainless steel housing and shield
- Velocity stack air inlet guide design for reduced air turbulence and improved airflow
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Installation Difficulty:
- Easy
- Tools Required:
- Basic Shop Tools
- Estimated Install Time:
- (approx.) 1 Hour
- Vehicle Fitment:
- 2005, 2006, 2007, 2008, 2009
- Vehicle Trim:
- GT
- Vehicle Trim:
- Bullitt
