Steeda's ProFlow Cold Air Intake for the S650 Mustang opens up the intake system to let the 4th Generation Coyote V8 breathe. With massive CNC-machined mass air meters and custom molded silicone tubes, this intake will impress. Our proven CNC-machined billet mass air meter delivers a clean signal to your mass air sensor for excellent response and driveability when getting off and on the throttle. This kit can utilize the factory airbox lids to retain the ram air effect of the stock airboxes, or the lids can be removed for an open intake that makes a statement at any show you go to.
Designed for peak performance. Utilizing decades of experience in tuning, designing cold air intakes, and racing Steeda has engineered this cold air intake to perform. It starts with our high-flow oiled air filters that reduce restriction. The CNC-machined mass air meter is massive at over 4.25" ID and allows for unrestricted airflow. Our custom-made 4-ply silicone intake tube starts at 4.75" ID and necks down to 95mm to increase velocity and also allow for throttle body upgrades.
Tested and proven. Steeda has tested this intake with different driving styles and situations to ensure compatibility with the factory programming. The result is an intake system that improves performance when installed, will not negatively affect drivability, and is ready to provide additional performance improvements when tuning becomes available.
Purchase your Steeda ProFlow Mustang 5.0L Cold Air Intake for 2024+ S650 at Steeda Autosports today!
- Over 25% larger velocity intake tubes than the competition
- Over 6% larger mass air meter than the competition
- No tune required
- Tested on the street and track
- 6061 billet aluminum mass air meters, CNC-machined in-house
- Superior MAF sensor signal
- 6061 billet aluminum PCV line fitting, CNC-machined in-house
- Maintains use of factory air boxes for ram air effect
- Lower intake temps than competitors open air CAIs
- Can be run in a closed or open lid configuration
- Smooth surface finish on machined parts
- Stainless steel hose clamps
- Custom-made 4-ply silicone hoses
- Reusable oiled air filters
- +13 peak hp, +11 peak tq over the leading competitor
- Limited lifetime warranty
- Made in the USA
Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.
Note: Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
This limited warranty is the only express warranty applicable to Steeda Autosports products. Other rights may arise or vary from state to state in the United States. Steeda is not responsible for any time for which you may lose the use of your vehicle, any inconvenience you might be caused, the loss of your transportation or any part thereof, or any other incidental or consequential damages you may have.
WARNING: California Residents: Cancer and Reproductive Harm; www.p65warnings.ca.gov
- Installation Difficulty:
- Easy
- Tools Required:
- Basic Shop Tools
- Estimated Install Time:
- (approx.) 1 Hour
- Vehicle Fitment:
- 2024
- Vehicle Trim:
- GT
- Engine Displacement:
- 5.0
- Air Filter Type:
- Oiled
- Cold Air Intake Type:
- Sealed
- Origin:
- Made in the USA
- Vehicle Trim:
- Dark Horse