Seven inches of additional suspension lift transforms the 4-door Base Bronco into a genuinely capable rock crawler and trail rig without sacrificing street drivability. Rough Country's no-struts lift kit for the 2021-2026 Bronco Base 4-Door uses heavy-duty steel knuckles, forged aluminum upper control arms, differential brackets, drop cross members, and upper strut spacers to achieve the full lift height while maintaining near-factory suspension geometry. The result is a level, aggressive stance with enough underbody clearance to run up to 40-inch tires with the correct wheel backspacing.
Geometry-focused engineering. Drop cross members and forged aluminum control arms work together to reduce CV joint angles, protecting the driveline under extended articulation. Proper CV geometry means less wear on axle shafts and consistent power delivery across the full suspension travel range, whether crawling over boulders or cruising on pavement.
Rear alignment and brake line management. A rear track bar relocation bracket keeps the axle centered under the lifted chassis, while brake line relocation brackets route factory lines safely at the new ride height. Both details prevent alignment drift and brake hardware stress that common on poorly engineered lift kits.
Optional Vertex coilovers for tunable performance. The kit pairs with Rough Country's Vertex Adjustable Coilovers for buyers who want independent control over ride height and damping. Adjustable compression and rebound settings let the driver dial in a setup for trail use, overlanding, or daily driving without swapping components.
DIY-friendly installation with known requirements. Installation takes approximately 6-8 hours for a dedicated home builder. Minor cutting and a strut compressor are required, so plan accordingly before starting. All hardware and mounting brackets are included for a complete, no-sourcing-extra-parts job.
Product Benefits
- 7-Inch Suspension Lift: Dramatically increases ground clearance for serious off-road capability.
- Forged Aluminum Upper Control Arms: Improve suspension geometry and reduce wear under load and articulation.
- Up to 40-Inch Tire Clearance: Supports aggressive tire fitment with proper wheel backspacing and an aftermarket bumper.
- Front-to-Rear Leveling: Eliminates the factory nose-down rake for a balanced, commanding stance.
- Reduced CV Angles: Drop cross members protect the driveline and maintain consistent power delivery.
- Rear Track Bar Bracket: Keeps the axle centered at the new lift height for proper alignment.
- Brake Line Relocation: Routes factory brake lines safely without stretching or binding.
- Limited Lifetime Replacement Warranty: Rough Country backs the kit against manufacturer defects for the life of the product.
Note: Fits 2021-2026 Bronco 4-Door Base models with 4WD only. Does not fit models equipped with the Sasquatch Package. Does not fit First Edition models, which come standard with the Sasquatch Package. Does not fit Badlands or Wildtrack models equipped with Ford's HOSS 3.0 suspension system. Does not fit Raptor models equipped with Ford's HOSS 4.0 suspension system. An aftermarket bumper is required to clear 40-inch tires. This listing is for the no-struts spacer kit; Vertex coilovers are sold separately.
About Rough Country: Rough Country designs and manufactures suspension lift kits, leveling kits, and off-road accessories for trucks and SUVs. The brand focuses on delivering complete, fitment-specific kits with the hardware and brackets needed for straightforward installation, backed by a limited lifetime replacement warranty on structural components.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
Product Specifications & Vehicle Fitment
Review the product details and confirm compatibility with your vehicle before ordering.
| Specification | Details |
|---|---|
| Vehicle Trim | Base, Black Diamond, Everglades, Heritage Edition, Outer Banks |
| Vehicle Fitment | 2021, 2022, 2023, 2024, 2025, 2026 |
