Three inches of front lift and a leveled rear stance transform a 2021-2026 2WD F-150 from a stock hauler into a truck that fills its wheel wells properly and clears real off-road terrain. Rough Country's bolt-on kit pairs forged aluminum upper control arms up front with rear lift blocks in the back, covering both ends of the truck in a single purchase with no permanent modifications required.
Forged aluminum upper control arms correct front suspension geometry. By replacing the factory stamped-steel UCAs, the kit corrects ball joint angles that go out of spec when you add lift, reducing wear on tie rods, ball joints, and CV axles. Rubber bushings throughout the assembly absorb road vibration and hold up against the flex cycles of daily driving and trail use alike.
Front strut spacers and rear lift blocks work together for a level stance. The strut spacers push the front end up three inches, while the rear lift blocks bring the tail of the truck in line. The result is a balanced, aggressive profile without the nose-up rake common on front-only leveling kits. With both ends raised, the truck can run up to 34-inch tires without rubbing the fender liner.
No cutting, no drilling, and no permanent changes to the factory chassis. The entire kit installs using basic hand tools in a home garage. Rough Country estimates five to six hours for a typical install, and every component unbolts cleanly if you ever want to return the truck to stock height.
Product Benefits
- 3-Inch Front Lift: Strut spacers raise the front end three inches for added ground clearance and aggressive stance.
- Forged Aluminum UCAs: Lightweight, high-strength upper control arms correct suspension geometry at lifted height.
- Optimized Ball Joint Angles: Proper geometry at ride height reduces wear on ball joints, tie rods, and CV axles.
- Rear Lift Blocks Included: Levels the rear of the truck to match the front lift for a clean, balanced look.
- Up to 34-Inch Tire Fitment: Increased clearance accommodates larger tires front and rear.
- Rubber Bushings: Dampen vibration and extend the service life of suspension pivot points.
- Bolt-On Installation: No cutting or drilling required; installs with basic tools in approximately five to six hours.
- Fully Reversible: All components unbolt cleanly so the truck can be returned to factory ride height.
- Limited Lifetime Warranty: Rough Country backs this kit against structural and workmanship defects.
Note: Fits 2021-2026 2WD F-150 only. Does not fit standard cab models. Does not fit models equipped with a continuous control damping (CCD) suspension system. Does not work on models with a stock ride height over 22 inches measured from the center of the wheel to the bottom of the fender. To retain factory wheels, Rough Country 0.25-inch wheel spacers (SKU: 1065) are recommended.
About Rough Country: Rough Country designs and manufactures lift kits, suspension components, and off-road accessories for trucks and SUVs. The brand focuses on accessible, bolt-on solutions that deliver meaningful lift and capability without requiring professional fabrication, backed by a limited lifetime warranty across its suspension lineup.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
Product Specifications & Vehicle Fitment
Review the product details and confirm compatibility with your vehicle before ordering.
| Specification | Details |
|---|---|
| Vehicle Trim | King Ranch, Lariat, Limited, Platinum, STX, XL, XLT |
| Vehicle Fitment | 2021, 2022, 2023, 2024, 2025, 2026 |
