Stock rotors on the 2011 F-150 3.5L EcoBoost handle daily driving well enough, but they were never built with extra-duty use or precision in mind. EBC's RK7536 front rotors close both gaps with G3000 spec cast iron, 100% runout inspection, and a Gen 3 silver grey Geomet-style coating that resists rust far better than the black etch paint used on earlier production.
Gen 3 silver grey coating sets a new standard. EBC switched to this highly corrosion-resistant finish in early 2023. Applied at the casting plant immediately after machining and washing, the coating bonds to bare iron before surface oxidation can begin. The silver tone also closely matches OEM rotor color, so swapping one axle at a time does not leave the front and rear looking mismatched.
G3000 spec cast iron construction. Every RK7536 is cast from G3000 grade iron, the same material specification used by original equipment suppliers. Rotor integrity determines how uniformly heat dissipates under hard braking; lower-grade iron introduces disc thickness variation that causes pedal pulsation after a few thousand miles. EBC's G3000 spec eliminates that risk.
100% runout inspection, no exceptions. Before any EBC rotor ships, it passes through runout measurement on dedicated inspection equipment. Not a sample batch, not a statistical pull, every single disc. Rotors that exceed specification tolerance are rejected, ensuring the disc that arrives at your door runs true and installs without vibration.
European and North American production. Over 80% of EBC rotor castings originate in Europe, and all machining on sport rotors happens in either the UK or the USA. That supply chain gives EBC direct control over material quality and dimensional tolerances at every stage.
Product Benefits
- Direct Fitment: Engineered specifically for the 2011 F-150 3.5L EcoBoost 2WD 7-lug front axle.
- Gen 3 Geomet-Style Coating: Silver grey finish delivers superior corrosion resistance compared to older black etch paint.
- G3000 Cast Iron: OE-grade iron specification minimizes disc thickness variation and pedal pulsation.
- 100% Runout Inspected: Every rotor is individually measured before leaving the facility.
- Coating Applied at Source: Paint applied immediately post-machining in an air-quality-controlled facility, before surface corrosion can form.
- Color-Matched Appearance: Silver tone aligns with factory rotor appearance for a consistent look across both axles.
- Controlled Manufacturing: Castings sourced predominantly from Europe; all sport rotor machining performed in the UK or USA.
About EBC Brakes: EBC Brakes is one of the world's largest aftermarket brake manufacturers, producing pads, rotors, and brake kits for passenger cars, trucks, and motorsport applications. The company operates its own machining facilities in the UK and USA, and applies strict dimensional and metallurgical standards across its full rotor lineup.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
Product Specifications & Vehicle Fitment
Review the product details and confirm compatibility with your vehicle before ordering.
| Specification | Details |
|---|---|
| Vehicle Trim | XL, XLT, Lariat |
| Vehicle Fitment | 2010, 2012, 2013, 2014 |
| FMSI Pad No. | D1414 |
