Rear rotors on the 2011 F-150 3.5L EcoBoost 2WD eventually succumb to surface rust, uneven wear, and the kind of thickness variation that causes pedal pulsation. EBC's RK7186 Premium Rotors replace them with a precision-cast, runout-inspected upgrade built to OEM fitment standards and finished with a corrosion-resistant Gen 3 silver grey coating.
G3000 spec cast iron construction. EBC machines these rotors from G3000 grade iron, the same specification used in original equipment brake components. Consistent density and controlled hardness across the rotor face resist the heat cycling and wear that cause premature disc thickness variation, keeping pedal feel linear over the life of the rotor.
Gen 3 silver grey Geomet-style coating. EBC's latest surface coating applies at the casting plant immediately after machining and washing, before surface oxidation can set in. The result is far greater corrosion resistance compared to the older thermic black etch finish, and the silver grey color closely matches factory rotor appearance so the front and rear axles look consistent even when only one axle is replaced.
100% runout inspection on every disc. No rotor leaves the facility without passing through EBC's dedicated runout inspection process. Dimensional accuracy at this level prevents the disc thickness variation that typically appears as brake pulsation between 3,000 and 4,000 miles, a common failure point with lower-quality replacement rotors.
European castings, precision machined in the UK or USA. Over 80 percent of EBC rotor castings originate from European foundries, and all sport rotor machining takes place in either the United Kingdom or the United States. That supply chain gives EBC direct control over metallurgy and dimensional tolerances from raw casting through final inspection.
Product Benefits
- Direct Rear Fitment: Engineered specifically for the 2011 F-150 3.5L EcoBoost 2WD 7-lug configuration.
- G3000 Cast Iron: OE-grade iron spec delivers consistent hardness and heat resistance.
- Gen 3 Corrosion Coating: Silver grey Geomet-style finish applied at the foundry for maximum rust protection.
- 100% Runout Inspected: Every rotor verified for dimensional accuracy before shipment.
- Matched Appearance: Silver grey finish closely matches factory rotor color when mixing new and existing axle hardware.
- European Castings: Over 80 percent of castings sourced from European foundries for tighter metallurgical control.
- UK or USA Machining: All sport rotor machining performed in the UK or United States.
About EBC Brakes: EBC Brakes manufactures brake rotors, pads, and hardware from facilities in the United Kingdom and the United States, supplying the OEM replacement and performance aftermarket worldwide. The brand controls the full production process from casting specification through final runout inspection, maintaining consistent quality across its rotor lineup.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
Product Specifications & Vehicle Fitment
Review the product details and confirm compatibility with your vehicle before ordering.
| Specification | Details |
|---|---|
| Vehicle Trim | XL, XLT |
| Vehicle Fitment | 2004, 2005, 2006, 2007, 2008, 2009, 2010 |
| FMSI Pad No. | D1012 |
