Stock rotors on the 2010-2014 Mustang V6 3.7L handle everyday street driving, but push them hard and heat soak, brake fade, and uneven pad wear become real concerns. EBC's GD7255 GD Sport Rotors address all three, bringing third-generation slotted and dimple-drilled rotor technology to the front axle of your V6 Mustang.
Wide-aperture slots that do real work. The GD series slots draw cool air under the pad-to-rotor interface during heavy braking, where temperatures at the heart of the brake pad can exceed 1,000 degrees. That active cooling effect helps suppress brake fade, promotes even pad wear, and continuously clears dirt, mud, water, and dust from the braking surface.
Dimple drilling without the cracking risk. EBC developed the dimple-drilled rotor in the 1990s specifically to provide pad degassing without cutting fully through the rotor face. Through-drilled holes create stress concentration points that promote cracking under repeated thermal cycling; dimple drilling delivers the same degassing benefit while preserving rotor integrity over the long term.
Third-generation corrosion protection. Every GD series rotor carries a silver corrosion-resistant finish that keeps the rotor looking clean and resists rust between drives, an important detail on a daily-driven street car exposed to rain and road grime.
ISO and TÜV-approved manufacturing. GD series rotors are 100% machined in the United Kingdom from R90-approved blanks, with the majority of castings sourced from EU facilities operating to ISO and BS5750 standards. Before release, every rotor receives a 100% runout, metallurgy, and dimensional check, plus balance and runout inspection, so each unit arrives ready to install.
Product Benefits
- Direct Front Fitment: Engineered specifically for the 2010-2014 Mustang V6 3.7L front axle.
- Active Brake Cooling: Wide-aperture slots draw cool air under the pad contact zone to fight heat soak and fade.
- Pad Degassing: Dimple-drilled surface allows gases to escape without the cracking risk of through-drilled holes.
- Debris Evacuation: Slot geometry continuously expels dirt, water, mud, and dust from the braking area.
- Corrosion-Resistant Finish: Silver protective coating extends rotor life on street-driven vehicles.
- R90-Approved Blanks: Raw castings meet the R90 safety regulation standard before machining begins.
- 100% Quality Inspection: Every rotor passes runout, metallurgy, dimensional, and balance checks prior to shipment.
- ISO and TÜV Certified Production: Manufactured in facilities approved to international quality and safety standards.
About EBC Brakes: EBC Brakes is a specialist brake manufacturer producing pads, rotors, and brake kits for street, track, and off-road applications. The company machines its GD series rotors in the United Kingdom and maintains strict quality controls across its global supply chain, including 100% dimensional, metallurgy, and runout inspection before any product leaves the facility.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
Product Specifications & Vehicle Fitment
Review the product details and confirm compatibility with your vehicle before ordering.
| Specification | Details |
|---|---|
| Vehicle Trim | GT, Shelby GT, Bullitt, Base |
| Vehicle Fitment | 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014 |
| FMSI Pad No. | D1464 |
