Stock front brakes on the 2005-2010 Mustang GT 4.6L were built for the street, not the track. The EBC Racing Apollo-4 355mm Big Brake Kit replaces the entire front braking system with hardware engineered and assembled in the UK, then backs it up with matching rear friction pads and braided lines so the whole car stops in balance.
A truly balanced brake upgrade. Most big brake kits stop at one axle. This kit ships with EBC Yellowstuff brake pads for the front Apollo-4 calipers, matching Yellowstuff friction pads for the stock rear calipers, and braided stainless brake lines for both front and rear. Upgrading one end without the other creates a brake bias problem; this kit solves that from the start.
Apollo-4 calipers built to a higher standard. The four-piston Apollo-4 calipers are cast, machined, painted, and assembled in the United Kingdom. Every caliper metal fitting and disc drive bobbin is machined from stainless steel to resist corrosion over time. Caliper brackets and the disc bell are machined from aerospace-grade billet aluminum for strength without unnecessary mass.
Yellowstuff pads included front and rear. EBC's Yellowstuff compound is formulated for fast street and track use, delivering firm, progressive bite from a cold start and resisting fade during extended hard driving. Front and rear pad sets ship with every kit, so there is no need to source additional friction material separately.
Complete hardware, no sourcing required. Every kit arrives with all the hardware needed to fully replace the stock front braking components, including braided lines for both axles. The result is a firmer pedal, more responsive modulation, and greater resistance to brake fade under sustained high-heat conditions.
Product Benefits
- Balanced System Upgrade: Front Apollo-4 calipers plus rear friction pads and braided lines for both axles included in one kit.
- 355mm Front Rotors: Larger disc diameter increases leverage and heat dissipation over the stock setup.
- UK-Engineered Apollo-4 Calipers: Cast, machined, painted, and assembled in the United Kingdom.
- Stainless Steel Hardware: Every caliper fitting and disc drive bobbin resists corrosion for long service life.
- Aerospace-Grade Billet Aluminum: Caliper brackets and disc bells machined for high strength at reduced weight.
- Yellowstuff Pads Included: EBC's fast street and track compound ships front and rear with the kit.
- Braided Stainless Lines: Front and rear lines replace expandable rubber hoses for consistent pedal feel.
- Direct Fitment: Engineered specifically for the 2005-2010 Mustang GT 4.6L front axle.
About EBC Racing: EBC Brakes has manufactured friction products and braking components in the United Kingdom for decades, supplying compounds and hardware for street, track, and motorsport applications. The Apollo Series represents EBC's commitment to full UK production, from casting to final assembly, across a range of platforms that spans daily drivers to dedicated circuit cars.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
Product Specifications & Vehicle Fitment
Review the product details and confirm compatibility with your vehicle before ordering.
| Specification | Details |
|---|---|
| Vehicle Trim | GT, Bullitt |
| Vehicle Fitment | 2006, 2005, 2007, 2009, 2008, 2010 |
