Steeda Ford Fusion Throttle Body Spacer - (10-12) 3.5L V6 Sport

8 Review(s)
$20.00 (20%)
Steeda's patented billet aluminum throttle body spacer is designed specifically for the 2010 and up 3. 5L Fusion Sport. This high quality piece is made from 6061 billet aluminum and designed to give you more plenum volume for increased horsepower.
Part Number: 555 3164
If Anderson Composites product is delivered defective or damaged, you must notify Steeda within 24 hours of delivery.

By checking this box, I accept these terms *

Write a Review


Steeda's patented billet aluminum throttle body spacer is designed specifically for the 2010 and up 3.5L Fusion Sport. This high quality piece is made from 6061 billet aluminum and designed to give you more plenum volume for increased horsepower.

The swirl design helps promote airflow by breaking the surface tension of the incoming air. An increase of horsepower and fuel milage should be seen with this part. Kit includes instructions gaskets and mounting hardware.

Increases of 2 to 4 horsepower are typical as well as an increase in fuel mileage.

Product Benefits
  • High quality construction
  • Made in the U.S.A. with pride
  • Increased horsepower and torque
  • Increased fuel economy
  • Made from quality billet aluminum

CA Residents: Cancer and Reproductive Harm WARNING

Fitment & Features


Manufacturer: Steeda Autosports

Installation Information:

Print Instructions: Installation Instructions

Vehicle Fitment:

Fits Model Year: 2010, 2011, 2012

Customer Reviews

Rating Snapshot

Select a row below to filter reviews.

Average Customer Ratings


Senior Sales Consultant, Technology
Not hard to install just follow the directions. May have improved HP a bit but never tested it by itself. I bought a SCT tuner through Steeda with lifetime tunes at the same time and THAT made all the difference! Whether I'm using the 87OCT or the 93OCT tune the car responds and drives like it should have the day it left the factory. I have the 2011 3.5L Fusion sport and this 'air spinner' with the cold air intake and the tune all through Steeda make for a very fun four door family car. For a seven year old car it will still 0-60 in under 6 sec! I'm also grateful to have the Steeda factory at my doorstep 10 minutes away. It really ads to the mod excitement to pick your part off the shelf where it was made then go home a play mechanic. Thanks Steeda!!!
Did you find this helpful?  7 of 7 Found Helpful
from Valdosta, GA USA on 5/10/2018
Faster acceleration
I was told on that this wasnt a good mod to add but I dont wanan mod out my Sport to much. I got a Free Injen intake for lending Injen my sport for a week, Have a the sport Magnaflow exhaust system and car runs great. I just added this space yesterday ( 12/05/14 ) It has a very noticable response in acceleration. I dont drive hard or race my car but it does pick up little more quicker now. Plus did the black friday promo so saved some $ and took bout 25 mins to install.
Did you find this helpful?  4 of 7 Found Helpful
from Florida on 12/6/2014
I haven't been able to measure hp, but there is a noticeable difference in torque and the idle has been smoothed a bit. I have also noticed that my mileage is increasing a bit. Only time will tell how much.
Did you find this helpful?  6 of 7 Found Helpful
from Georgia on 8/9/2014
Easy to install
This is the second aftermarket part I installed onto my 2012 Ford Fusion Sport AWD, after installing the Magnaflow Cat-back exhaust kit. I ordered the TB spacer and the strut tower brace. The order shipped they day after I placed the order and parts arrived sooner then the estimated delivery date. I'm not sure if the TB spacer has given me more horsepower, but it does seem to have improved my gas mileage a bit as I can now go 400 miles on a tank of gas v. 389 miles on the stock Fusion Sport AWD.
Did you find this helpful?  7 of 7 Found Helpful
from Florida on 5/27/2014
Easy mod
I bought this thinking it would be a relatively cheap and easy mod. I installed this after installing a front strut brace from Steeda. Well this piece was very easy to install. I'm not really sure of any immediate noticeable difference as of yet, but I will say very easy to install.
Did you find this helpful?  1 of 3 Found Helpful
from Florida on 9/28/2013
Easy install
The install was easy. The instructions that came with the product were easy to understand. Can't easily see the Spacer, but I know its there and I love the way it looks.
Did you find this helpful?  2 of 4 Found Helpful
from Georgia on 4/27/2013
Simple and effective!
This being a part that enhances how well your engine can breathe makes it a must. It is an essential part to compliment your Steeda cold air intake. I installed both and couldn't tell you the exact results. I do know that the better your car breathes and mixes the the air and fuel, the better it's going to run. Recommended for anyone with the intent of getting the intake, exhaust, and tuner. The power gains will be much more noticeable with a custom tune for sure! Thanks for another amazing part Steeda!
Did you find this helpful?  2 of 2 Found Helpful
from Texas on 10/8/2012
Would recommend
Installed last week on 2010 Sport. Noticed acceleration is smoother and motor doesn't kick down as much. You can give half throttle and car moves. Not sure on mileage yet as to soon to tell.
Did you find this helpful?  3 of 3 Found Helpful
from Texas on 3/19/2012
There are no reviews for this product!

Related Items

123123 - 1
Back to TOP
0 Items