Protect your 2019-2027 Ranger's bed while keeping oversized hauling an option with the Lomax Stance Hard Folding Tonneau Cover. Three finish choices, a vertical stand-up position for full bed access without cover removal, and a 400-lb distributed load rating make this one of the most capable hard folding covers available for the Ranger platform. Made in the USA and backed by a 3-year Limited Warranty, it delivers long-term value without compromise.
Vertical position capability changes how you haul. The RigidLink locking system secures the folded cover at approximately 90 degrees behind the cab, giving you unrestricted bed depth for lumber, appliances, or oversized gear without ever unbolting anything. Powder-coated steel pivot links with rubber bushings keep the cover stable and prevent contact with the rear window.
Automatic dual locking keeps security simple. A single cord pull from either side releases both latches simultaneously, and unfolding each panel re-engages the automatic ten-point locking system without keys or extra steps. Heavy-duty reinforced nylon latches provide a half-inch surface for solid, positive engagement every time.
Water stays out without gutters or drains. Waterproof hinges and a continuous seal along the full length of both side rails route water away from the bed through the cover's own water-shedding geometry. No add-on drainage hardware is needed, and the weathertight seal sits flush with the bed rail for a clean, low-profile appearance that protrudes less than half an inch above the bed surface.
Installation requires no drilling. The Tight Bite clamp system uses precisely cut teeth to grip the bed rail with superior holding strength. Eight clamps distribute load evenly, and the entire cover goes on in minutes using basic hand tools. Molded storage brackets with retractable bungees hold panels properly spaced and secure when folded, with no field adjustments required.
Three finish options match any build. The Stance is available in urethane aluminum, urethane diamond plate, and urethane carbon fiber, so the cover complements everything from a work truck to a trail-built Ranger. Extruded aluminum channels reinforce the panels to handle 400 lbs of evenly distributed static weight while keeping the cover's total weight in the 50-60 lb range for a high strength-to-weight ratio.
Product Benefits
- Vertical Stand-Up Position: RigidLink system locks the cover upright at approximately 90 degrees for full, unobstructed bed use without removal.
- Automatic Dual Locking: Single cord pull from either side releases both latches; unfolding re-engages automatically.
- 400-lb Load Rating: Extruded aluminum channels support up to 400 lbs of evenly distributed weight.
- Weathertight Seal: Continuous side-rail seals and waterproof hinges shed water without gutters or drains.
- Less Than 1/2 Inch Bed Protrusion: Low-profile fit keeps the cover nearly flush with the bed rail.
- No-Drill Installation: Eight Tight Bite clamps grip the bed rail securely without drilling.
- Three Finish Options: Urethane aluminum, urethane diamond plate, or urethane carbon fiber.
- Molded Storage Brackets: Bungee and molded brackets hold panels spaced and secure in the folded upright position.
- Made in the USA: Manufactured domestically by Agri-Cover
- 3-Year Limited Warranty: Covered against defects for three years from purchase.
About Lomax: Lomax is a tonneau cover brand produced by Agri-Cover, headquartered in Jamestown, North Dakota. Agri-Cover engineers and manufactures its covers domestically, focusing on durable, driver-friendly designs that balance security, weather protection, and practical bed access across a wide range of truck platforms.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
- Vehicle Fitment:
- 2019, 2020, 2021, 2022, 2023, 2024, 2025, 2026, 2027
