Standard sound deadening sheets pile on layer after layer to chase road noise, adding weight and bulk without fully solving the problem. Heatshield Products' db Sniper takes a different approach: a single quarter-inch layer of closed-cell neoprene foam bonded to a dense vinyl underlayer that reflects high-frequency noise and absorbs low-frequency vibrations at 200 MHz and below, delivering the noise-blocking performance of four to six conventional layers in a fraction of the thickness.
A true sonic barrier, not just a damper. The construction creates a floating sound shield that stops road noise before it enters the cabin rather than simply deadening it after the fact. High-frequency waves reflect off the dense vinyl layer while low-frequency vibrations dissipate through the neoprene foam, addressing the full spectrum of interior noise.
Lightweight construction for performance builds. At just one pound per square foot and only 0.250 inches thick, db Sniper adds meaningful noise control without the weight penalty that stacks of traditional deadening material carry. Keeping weight down matters in performance, off-road, and restoration applications where every pound counts.
Straightforward installation on flat and gently curved surfaces. db Sniper fits floor pans, firewalls, trunks, and rear panels. Clean and degrease the surface, use the existing floor mat as a cutting template, trim to size, and bond with adhesive spray. No special tools, no complex fitting.
Product Benefits
- Equivalent to 4-6 Layers: One layer matches the noise-blocking performance of four to six sheets of standard sound deadening.
- Dual-Material Construction: Closed-cell neoprene foam paired with a dense vinyl underlayer handles both high-frequency reflection and low-frequency absorption.
- Quarter-Inch Profile: At 0.250 inches thick, it installs under floor mats and panels without creating fitment issues.
- Lightweight: One pound per square foot keeps the weight penalty minimal for performance and off-road builds.
- Versatile Fitment: Designed for flat or gently curved surfaces including floor pans, firewalls, trunks, and rear panels.
- Simple Install: Cut to size with scissors or a knife, bond with adhesive spray, and use factory floor mats as a template.
- Made in the USA: Manufactured domestically for consistent quality and material standards.
About Heatshield Products: Heatshield Products designs and manufactures thermal and acoustic insulation solutions for automotive, motorsport, and industrial applications. Every product in the lineup is made in the USA and engineered to solve specific heat and noise problems without adding unnecessary bulk or complexity.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
