Wires, fuel lines, brake lines, and vacuum hoses routed through an engine bay face constant threats from vibration, metal edges, and chemical exposure. The HP Abrasion Shield from Heatshield Products wraps directly over existing lines without disconnecting a single fitting, delivering PET braided protection rated for over 30,000 abrasion cycles and temperatures from -40°F to 302°F continuous, with intermittent peaks to 347°F.
Expandable braid installs without disassembly. The sleeving stretches to slide over hoses, AN lines, and wiring harnesses in place, even through tight bends and congested engine bays. Once in position, secure it with zip ties, clamps, or stainless locking ties. No need to drop a fuel line or pull a connector to get a clean, protected run.
Flame-retardant construction meets FMVSS 302. The PET braid is self-extinguishing, so it complies with the Federal Motor Vehicle Safety Standard for flammability. In a race car, an off-road build, or a daily driver, that compliance matters when lines run near exhaust or ignition sources.
Resists the fluids and debris that degrade standard sleeving. The HP Abrasion Shield holds up against oil, fuel, coolant, and common automotive chemicals, so it stays functional long after a typical wrap or split loom has soaked through and softened. Available in six diameter options from 1/2 inch to 2 inches, and in 3-foot or 6-foot lengths, it trims cleanly to any run length.
Product Benefits
- Over 30,000 Abrasion Cycles: Outlasts standard split loom and foam wrap in high-vibration, high-contact areas.
- FMVSS 302 Compliant: Flame-retardant and self-extinguishing PET braid meets federal flammability standards.
- Wide Temperature Range: Handles continuous service at -40°F to 302°F with intermittent peaks to 347°F.
- No-Disconnect Installation: Expandable braid wraps over lines and fittings in place without disassembly.
- Chemical Resistant: Resists oil, fuel, coolant, and common under-hood fluids.
- Multiple Sizes: Available in 1/2, 3/4, 1, 1-1/4, 1-3/4, and 2-inch diameters in 3-foot and 6-foot lengths.
- Trimmable to Length: Cuts cleanly so nothing goes to waste on custom or complex routing.
- Made in the USA: Manufactured domestically by Heatshield Products.
About Heatshield Products: Heatshield Products engineers thermal and abrasion protection solutions for automotive, motorsports, and industrial applications. Every product in the lineup focuses on practical protection: keeping heat where it belongs, shielding components from abrasion, and standing up to the fluids and temperatures found in real-world engine bays.
WARNING: California Residents: Cancer and Reproductive Harm;
www.p65warnings.ca.gov
