Steeda GT500 Mustang BIG BORE Cold Air Intake (13-14 GT500)

List price: $399.95
$359.95
You save: $40.00 (10%)
Price in points: 360 points
555-3173
+

Designed, tested, and assembled all in-house. This kit completely replaces the factory intake assembly. This kit is specifically designed to utilize the factory cold air feed from the grille and incorporates a serviceable high flow air filter, an injection molded high flow intake tube, billet velocity stack, and black powder-coated heat shield.

With a huge 130mm mass air flow tube diameter we achieved a substantial increase in air flow at all engine rpm's, not just at redline. Because of the huge size of the mass air housing this kit must be used with a custom tuning device such as our SCT tuners. The heat shield seals to the hood liner and also keeps the factory cold air feed duct to keep out hot engine bay air for maximum power.

Power gains are substantial when combined with our required SCT custom tuning. Peak to peak gains of up to 60 horsepower can be expected, with point to point horsepower gains of over 70 horsepower. You can expect peak to peak torque gains of up to 54 ft/lbs with point to point gains of over 68 ft/lbs.

Our easy to install kit comes with premium hardware, silicone sleeves, and installation instructions.

Product Benefits

  • Gains up to 70 horsepower and 68 lb/ft of torque!
  • Utilizes the factory cold air feed duct from the grille for low air charge temperatures
  • Beautiful black powder-coated heat shield
  • ProFlow roto molded intake tube offers minimal heat soak maintaining cool air charge temps

Read more about the advantages in Steeda Mustang Cold Air Intakes over the competitors on our blog: http://www.steedablog.com/2012/03/mustang-cold-air-intake-truth/

Warning: Not approved for sale in California or states that require a California E.O. #. This part has been designed and is intended for off-road application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations.

Note: Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Steeda Autosports assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of Steeda products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

This limited warranty is the only express warranty applicable to Steeda Autosports products. Other rights may arise or vary from state to state in the United States. Steeda is not responsible for any time for which you may lose the use of your vehicle, any inconvenience you might be caused, the loss of your transportation or any part thereof, or any other incidental or consequential damages you may have.

Installation Information

Level of Difficulty:
Easy
Time of Install:
About 1 Hour
Tools Required:
Basic Tools

Manufacturer

Made in USA:
Yes
Manufacturer:
Steeda Autosports

Vehicle Fitment

Fits Model Year:
  • 2013
  • 2014
Mustang Model:
  • GT500
Transmission Type:
  • Manual